Kenwood TM-241A Instruction Manual page 56

REMOTE CONTROLLER RC-10
To operate the transceiver with the RC-10 press and
hold the CALL key on the transceiver and then turn on
the POWER switch.
To select the CALL channel when using the RC-10 press
the F key on the RC-10 and then the VFO key.
Please refer to the Instructions provided with the RC-10
for a description of the other RC-10 functions.
Functions that gan be controlled by the RC-10
UZ]
)
2)
iC
SI)
Ce)
@LCD (liquid crystal display)
Indicates the transmit/receive frequencies and other
conditions.
56
@Keyboard
Can be used to select the transmit/receive frequen-
cies (0 to 9, AandW keys), to select memory channels
(1 to 10), and to select channel 11 or subsequent
channels during memory calling ( & and Wkeys).
@F (Function) key
The following functions can be controlled by combin-
ing the F key with other keys.
F.1
F.2
F.3
F.4
FS
i 4
F.8
F.0
F.VFO
ALT function is on (TM-541A/E only).
When the transceiver squelch is on, the
squelch is switched in or out each time this
key is pressed.
The shift can be switched to +, -, and sim-
plex each time this key is pressed.
REV (reverse) is turned on and off each
time this key is pressed.
The TONE and CTCSS functions are turned
on and off each time this key is pressed.
The memory channel lockout is turned on
and off each time this key is pressed.
The RC-10 keys are locked and unlocked
each time this key is pressed.
Cotrols switching to duplex using two
transceivers.
The call channel is turned on and off each
time this key is pressed.