Frequency Selection - Kenwood TM-631A Instruction Manual

4-2-2. Frequency Selection
Frequency can be changed in the VFO mode. The selected
frequencies of the main band can be stored in the Memory
channels, and the Call channel.
(See Memory Entry page 23, CALL CHANNEL page 25.)
You can select the VFO mode, MEMORY Channel mode,
and CALL Channel mode using the following keys.
VFO mode
MR key CALL key
VFO key VFO key
CALL key
MEMORY Channel mode | ———————|_ CALL channel mode
MR key
It is impossible to change the mode directly in the SUB band.
It is possible to transfer the mode of the MAIN band to/from
SUB band.
Exchange the Band
Press the BAND key. Each time the BAND key is pressed,
the contents of the SUB band are exchanged with the MAIN
band.
© VFO mode i \ine
2. Rotate the MAIN Tuning control, MHz
keys, or Microphone UP/DWN swit-
ches to select the desired frequency.
16
® Memory Recall mode
. Press the MR key. The previously
selected memory channel will be dis-
played on the LCD display.
2. Rotate the MAIN Tuning control or
Microphone UP/DWN switches to
select the desired Memory Channel.
3. To return to the VFO mode press the
VFO key.
=
@ CALL Channel mode
. Press the CALL key to select the CALL
Channel mode. The CALL indicator and "= G
the call channel frequency are dis- 5 4 J
played on the LCD display.
2. To return to the previous mode press
the CALL key again.
Note: —
CALL Channel mode, if the call channel is selected from the
MR mode.
=
@ SUB BAND
° If the current frequency is in VFO
mode; Rotate the SUB Tuning control
to select the desired frequency.
e If the current frequency is in MR mode;
Rotate the SUB Tuning control to select
the desiréd Memory Channel.
© Current frequency is in CALL Channel mode; Frequency
can not be changed in the SUB band.