Programmable Band Scan - Kenwood TM-241A Instruction Manual

5-5-3. Band Scan
ran
. Press the VFO/MP V key to select the VFO mode.
2. Adjust the SQL control to the threshold point.
3. Press and hold the VFO / MPV key for longer than 1
second.
The MHz indicator will flash as a visual reminder the
transceiver is scanning.
Press and hold the VFO / MPV key for longer
than 1 second.
4.Scan will begin in an upward direction.You can
reverse the direction by rotating the Tuning control
counterclockwise, or by pressing the microphone
DWN switch. The scan step size depends upon the
current step programming.
5. Scan will stop whenever a signal is received (that
activates the BUSY indicator) for a limited time.
6. Press the PTT switch or any front panel key to stop
scan.
26
5-5-4 Programmable Band Scan
1. The lower scan limit must be stored in memory chan-
ne! 11. The higher scan limit must be stored in mem-
ory channel 12.
Notes
If the frequency in Memory Channel 11 is equal to or
greater than the frequency stored in Memory channel
12 scan will proceed over the entire band''Band
Scan'.
2. Adjust the SQL control to the threshold point.
3. Press the VFO/ MP V key to select the VFO mode.
4.Select a VFO frequency between the two
programmed scan limits.
5. Press and hold the VFO/ MPV key for longer than 1
second. The MHz indicator will flash as a visual
reminder the transceiver is scanning.
Press and hold the VFO/ MPV key for longer
than 1 second.
Flashing
6. Scan will begin in an upward direction.You can
reverse the direction by rotating the Tuning control
counterclockwise, or by pressing the microphone
DWN switch.
7. Sean will stop whenever a signal is received (that
activates the BUSY indicator) for a limited time.
8. Press the PTT switch or any front panel key to stop
scanning.