Kenwood TM-241A Instruction Manual page 14

Indicates the active memory channel
number. * indicates that the chan-
nel is locked out.
C is displayed during call channel.
Either PO, P1, P2, P3, or PA is dis-
played during paging.
On whenever the F key has been de-
pressed. Also shows the last memory
channel number that had been se-
lected.
xe) Q On when the Tone Alert function is
active. The indicator flashes when
signal has been received.
@CTCSS On when the Tone Decode and En-
{ code function has been activated.
On when the Tone Encode function
has been activated.
®, 8G
eF |
@® AL On when the Priority Alert function
has been activated.
4) REV On when the Reverse function has
been activated.
Q- + Display the selected transmitter off-
set direction.
Both — and + light at the same
@ time during split channel operation.
! Displays the operating frequency to
888885 the nearest kHz digit; or the tone
frequency etc.
The indicator flashes when scan-
ning.
5-1-3. Rear Panel
ES
Os
—
:
x
eee
@ ANTENNA connector
Attach an antenna with a
impedance of 50 ohms.
@ 13.8 VDC power input connector
Connect the supplied DC power cable to this
connector.
Pay close attention to the polarity. Red is positive and
black is negative.
@ Fuse holder
Contains a requaired fuse.
TM-241A: 15A, TM-441A: 10A, TM-541A: 8A
Do not use a larger fuse as damage might result to
the transceiver.
@ External speaker jack
This jack is used to connect an external speaker. The
speaker should have an impedance of 8 ohms.
e
low SWR and an