Memory Channelscan; Memory Channel Lockout - Kenwood TM-241A Instruction Manual

5-5-5 Memory Channel Scan
1. Adjust the SQL control to the threshold point.
2. Press and hold the MR/M key for longer than 1 sec-
ond. The MHz indicator will flash as a visual reminder
the transceiver is scanning.
Press and hold the MR/M key for longer than 1
second.
Notes
1. The transceiver will not scan if there is only one memory chan-
nel.
2. The transceiver will skip any locked-out channels.
3. The transceiver will scan only the memory channels in which
frequencies have been stored.
w
Scan will begin at the current memory channel and
proceed sequentially .i.eM1 — M2 — M3 etc. Only
those memory channels with data entered are
scanned.
4. Scan will stop whenever a signal is received ( that ac-
tivates the BUSY indicator) for a limited time.
5. Press the PTT switch or any front panel key to stop
scanning.
5-5-6 Memory Channel Lockout
The Memory Channel Lockout function allows you to
temporarily skip unwanted Memory Channels during
Memory Channel scan.
1. Press the MR/M key to select the Memory Channel
mode.
2. Select the Memory Channel that you wish to skip by
using the Tuning control or the microphone UP/DWN
switches .
3. Press the F key for longer than 1 second. The F indica-
tor will flash. Within 10 seconds of pressing the F key
press the MR/M key. A star (*) will appear to the left
of the Memory Channel number . This indicates the
Memory Channel will be skipped during the Memory
Channel scan operation.,
Press the key for longer than
1 second.
4. Repeat steps 2 and 3 to lock out any other Memory
Channel that you want to skip
. To cancel the lockout , select the desired Memory
Channels as described in step 1,2,and 3 above.
The star (%) will go out. The Memory Channel will
now be scanned normally.
ao
27