Parameter List; Parameter List (By Parameter Number) - Mitsubishi Electric FR-CS82S-025 Instruction Manual

5
PARAMETERS
This chapter explains the function setting for use of this product.
Always read the instructions before use.
The following marks are used to indicate the controls. (Parameters without any mark are valid for all the controls.)
Mark
V/F V/F
GP MFVC GP MFVC
5.1

Parameter list

5.1.1

Parameter list (by parameter number)

For simple variable-speed operation of the inverter, the initial values of the parameters may be used as they are. Set the
necessary parameters to meet the load and operational specifications. Parameter setting, change, and check can be made on
the operation panel.
NOTE
• The changing of the parameter settings may be restricted in some operating statuses. Use Pr.77 Parameter write selection
to change the setting.
Pr.
Pr.
group
0 G000
1 H400
2 H401
3 G001
4 D301
5 D302
6 D303
7 F010
8 F011
9 H000
10 G100
11 G101
12 G110
— 13 F102
72
5. PARAMETERS
5.1 Parameter list
Control method
V/F control
General-purpose magnetic flux control
Name
Torque boost
Maximum frequency
Minimum frequency
Base frequency
Multi-speed setting (high
speed)
Multi-speed setting (middle
speed)
Multi-speed setting (low
speed)
Acceleration time
Deceleration time
Electronic thermal O/L relay
DC injection brake operation
frequency
DC injection brake operation
time
DC injection brake operation
voltage
Starting frequency
Three-phase induction motor
Minimum
Setting range setting
increment
0 to 30% 0.1%
0 to 120 Hz 0.01 Hz
0 to 120 Hz 0.01 Hz
10 to 400 Hz 0.01 Hz
0 to 400 Hz 0.01 Hz
0 to 400 Hz 0.01 Hz
0 to 400 Hz 0.01 Hz
0 to 3600 s 0.1 s
0 to 3600 s 0.1 s
0 to 500 A 0.01 A
0 to 120 Hz 0.01 Hz
0 to 10 s 0.1 s
0 to 30% 0.1%
0 to 60 Hz 0.01 Hz
Applied motor
Refer to Customer
Initial value
page
*1
6%
*1
4%
193
*1
3%
*1
2%
120 Hz 117
0 Hz 117
50 Hz 194
50 Hz 109
30 Hz 109
10 Hz 109
*2
5 s
*2
93
10 s
*2
15 s
*2
5 s
*2
93
10 s
*2
15 s
Inverter
112, 147
rated current
3 Hz 197
0.5 s 197
*3
4%
197
*4
2%
0.5 Hz 99
setting