Mitsubishi Electric FR-CS82S-025 Instruction Manual page 108

*3 In the PU JOG operation mode, the operation always stops when the PU is disconnected. The operation at a PU disconnection fault (E.PUE)
occurrence is as set in Pr.75 Reset selection/Disconnected PU detection/PU Stop selection.
 Selecting the command interface enabled in the Network operation mode
(Pr.338, Pr.339)
• Selecting a command interface is required for the following two commands: the operation command using the start signals
and the signals related to the inverter function selection, and the speed command using signals related to the frequency
setting.
• The following table shows the command interface enabled in the Network operation mode: the external terminal or the PU
connector for communication operation.
Pr.338 (Communication operation command
Command
interface
Pr.339 (Communication speed command
selection
Running frequency command given through
Unique function
communication
(terminal-
specific Terminal 2
function)
Terminal 4
Low-speed operation command / Remote
0 RL setting (setting clear) / Stop-on-contact
selection 0
Middle-speed operation command /
1 RM
remote setting (deceleration)
High-speed operation command / remote
2 RH
setting (acceleration)
Second function selection / stop-on-
3 RT
contact selection 1
4 AU Terminal 4 input selection
5 JOG JOG operation selection
7 OH External thermal relay input
8 REX 15-speed selection
10 X10 Inverter run enable
14 X14 PID control valid
Output stop
24 MRS
PU operation interlock
STP
25 Start self-holding selection
(STOP)
37 X37 Traverse function selection
60 STF Forward rotation command
61 STR Reverse rotation command
62 RES Inverter reset
[Explanation of Terms in Table]
EXT: The external terminal is the only enabled command interface.
NET: The PU connector (for communication operation) is the only enabled command interface.
Combined: Either interface (the external terminal or PU connector) is enabled.
—: Both interfaces (the external terminal and PU connector) are disabled.
NOTE
• The command interface/source for communication operation depends on the Pr.551 setting.
• The settings of Pr.338 and Pr.339 can be changed while the inverter is running when Pr.77 = "2". Note that the setting change
is applied after the inverter has stopped. Until the inverter has stopped, communication operation command source and
communication speed command source before the setting change are valid.
source) setting
source) setting
0: NET 1: EXT
0: 1: 2: 0: 1:
NET EXT EXT NET EXT
NET — NET NET —
— EXT — — EXT
— EXT — EXT
NET EXT NET EXT
NET EXT NET EXT
NET EXT NET EXT
NET EXT
— Combined — Combined
— EXT
EXT
NET EXT NET EXT
EXT
NET EXT NET EXT
Combined EXT
EXT
— EXT
NET EXT
NET EXT
NET EXT
EXT
5.5 (D) Operation command and frequency command
Remarks
2:
EXT
NET
—
When Pr.59 = "0": Multi-
speed, when Pr.59 ≠ "0":
Remote
When Pr.59 = "0": Multi-
speed
5. PARAMETERS
2
2
3
4
5
6
7
8
9
10
107