Table of Contents
Advertisement
SECTION 10—PERIODIC MAINTENANCE GUIDELINES
When anti-tippers are used, anti-tippers MUST be adjusted to maintain a 50 mm
minimum clearance between the top of the anti-tipper wheels and the rear wheel
tire circumference. This spacing should always be checked whenever
adjustments/changes are made to the wheelchair.
Failure to maintain proper spacing may result in the chair tipping over backward
causing serious injury or property damage
Adjusting Anti-Tippers when Swing Inwards
NOTE: For this information, refer to FIGURE 9.3.
1. Adjust anti-tipper when swing inwards thanks to combination of height, angle and
depth adjustments.
2. Adjust the angle of the anti-tipper to maintain à 30 mm minimum clearance between
the top of the anti-tipper wheels and the tire circumference, see Adjusting Anti-Tipper
Angle paragraph.
3. Secure the assembly with the mounting bolts
(M6) of the anti-tipper housing.
NOTE: The anti-tippers when swing inwards must be adjusted to maintain à 30
mm minimum clearance between the top of the anti-tipper wheels and the tire
circumference to avoid anti-tipper sink into the ground. Re-adjust angle if
necessary.
NOTE: A table with combination of front wheels, rear wheels, seat depths and seat
heights is available on demand.
50 mm Mini
30 mm Mini
W A R N I N G
FIGURE 9.3
Adjusting Anti-Tippers when Swing Inwards
B
(M5) and mounting screws/locknut
DETAIL "A"
4 4
Factory Settings
10° to 15°
Advertisement
Table of Contents
