Table of Contents
Advertisement
Adjusting the Rear Wheel Camber
NOTE: For this procedure, refer to FIGURE 5.8.
1. Remove the wheel. Refer to Removing/Installing Rear Wheels paragraph.
2. Loosen, but DO NOT remove, the top mounting screw and remove the bottom
mounting bolt that secure the bottom of the axle plate to the wheelchair frame and
rule out the axe plate from the frame.
The axle plate must be moved with care. Otherwise, scratching and slight
frame damage may occur.
3. Insert the number of spacer required to achieve the desired camber position as shown
in Detail "A".
Camber positions "0°"; "1°"; "2°" are possible with the standard configuration, refer to Detail "A"
Camber Settings; "3°" and "4°" camber positions can be performed with the additional kit (#
1604403), see detailed Mounting Instruction (# 1607075) at the end of this manual.
4. Re-insert the bottom mounting screw that secure the bottom of the axle plate and
tighten the bolt, retighten the top mounting screw.
After ANY adjustments, before use, make sure all attaching hardware is
tightened securely - otherwise injury or damage may occur. When changing
the camber position of the rear wheels, the wheel locks MUST be repositioned,
refer to Adjusting Wheel Lock Position paragraph and to the Mounting Instruction.
5. Repeat STEPS 1 to 4 for the other side.
NOTE: Both axle plates should be set at the same camber position.
Top mounting
screw (M6)
Axle plate
Spacers
Bottom mounting
bolt (M6)
SECTION 5—REAR WHEELS/FRONT CASTORS
C A U T I O N
W A R N I N G
DETAIL "A"
FIGURE 5.8 Adjusting the Rear Wheel Camber
2 9
Camber Settings
Advertisement
Table of Contents
