Section 8 - O P T I O N S; Installing/Adjusting Dual Handrim (Dhr) - Invacare Action 5 Service Manual

Hide thumbs Also See for Action 5:

Table of Contents

S E C T I O N 8 — O P T I O N S

After ANY adjustments, repair or service and BEFORE use, make sure all attaching

hardware is tightened securely - otherwise injury or damage may occur.

Make sure the detent pin and locking pins of the quick-release button are fully

released before operating the wheelchair.

The locking pins MUST be protruding past the inside of rear wheel hub for a positive

lock. Keep locking pins clean.

Ensure both wheels are adjusted to the same mounting hole.

Installing Dual Handrim (DHR)

NOTE: For this procedure, refer to FIGURE 8.1.

1. Remove the rear wheel. Refer to Removing/Installing Rear Wheels paragraph.

2. Remove the locknut and washer that secures the axle bracket to the axle plate.

3. Align the DHR Axle bush with one of the four adjustment holes on the axle plate

4. Secure the DHR axle bush to the axle plate, at the desired height, with the locknut

and washer. Insert the wheel with the axle DHR wheel axle into the DHR axle bush

Repeat STEPS 1 to 6 for the other rear wheel.

Insert the gear shaft onto the end of the wheel axle to connect both DHR wheels.

Axle plate

(4 holes)

W A R N I N G

Quick release

button

FIGURE 8.1

Installing Dual Handrim

4 1

SECTION 8—OPTIONS

DHR wheel

axle

DHR axle bush

Locknut & Washer

Gear shaft

Table of Contents

Myon hc