Table of Contents
Advertisement
SECTION 4—SEAT/BACK
Replacing
1. Lift on the existing back upholstery cover and remove the cover from the
wheelchair.
2. Remove the two mounting screws that secure the existing adjustable back
upholstery to the back-canes.
3. Slide each section (anchor loop/adjuster strap) of the existing adjustable back
upholstery from the back-canes.
4. Slide each section (anchor loop/adjuster strap) of the new adjustable back upholstery
with the grommet hole facing the rear of the wheelchair.
5. Secure new adjustable back upholstery to the back canes with the two mounting
screws.
Ensure that the wheelchair is fully opened and the seat rails properly located. The
fastening strips MUST be securely fastened before applying the back upholstery
cover. The Contour (adjustable) back should be checked whenever entering the
wheelchair to ensure that the fastening strips are securely fastened.
6. Slip adjuster strips through corresponding anchor loops and adjust the back
upholstery. Secure with the fastening strips.
7. Secure the new back upholstery cover (fastening strap) to the back of the new
adjustable back upholstery (fastening strap).
8. Flip the new back upholstery cover over the new adjustable back upholstery and
secure the fastening strips to the front of the new adjustable back upholstery.
9. Lay the front portion of the new back upholstery cover on the seat upholstery.
10. Adjust the slack in the new back upholstery cover and then secure to the seat
upholstery.
Back-cane
Mounting screw
Back Upholstery
Anchor Loop
Back upholstery
adjuster strap
Adjustable back upholstery
W A R N I N G
FIGURE 4.5 Installing/Replacing
Contour (adjustable) Back Upholstery
1 8
Back upholstery cover
Fastening straps
Fastening straps
Advertisement
Table of Contents
