Lubrication; Assembly; Rip Fence; Miter Gauge - Craftsman 113.24181 Owner's Manual

LUBRICATION
The saw motor bearings have been packed at the factory
with proper lubricant and require no additional lubrication.
1. Lay the saw on its LEFT SIDE.
2. Clean the following parts with Craftsman Gum and
Pitch Remover; BEVEL GEARS, ELEVATION WORM
AND TEETH, TILT WORM AND TEETH.
Lubricate these parts and other bearing points indicated,
with SAE No. 20 or No. 30 engine oil.
The following parts should be oiled occasionally with SAE
No. 20 or No. 30 engine oil.
Bearing points in guard assembly, miter gauge and rip fence.
GUARD 'm _:
_ MITER GUAGE
_lk BEARING POINTS
-/ ..... _-_v,'_/ TILT WORM AND TEETH WORM AND TEETH
I I II I
RECOMMENDED ACCESSORIES
IN CANADA, SEE YOUR LOCAL SIMPSONS-SEARS STORE
OR CATALOG FOR ACCESSORY SELECTION AND NUMBERS.
ITEM CAT. NO. ITEM CAT. NO.
Retractable Caster Set ............ 9-22201 - 9-22209
7 In. Molding Head Set ...................... 9-3217
7 In. Molding Head Set ...................... 9-3218
7 In. Molding Head ......................... 9-3214
Molding/Dedo Insert for 7 in.
Dia. Molding or Dado Head ................. 9-29995
Work Light ............................... 9-2480
Work Light ............................... 9-2481
7 In. Dia. Adjustable Dado Head .............. 9-3263
7 In. Dia. Dado Head ....................... 9-3257
Blade Stabilizers ........................... 9-4952
Sanding Wheel ........................... 9-22723
Miter-Gauge Stop Rods ..................... 9-29924
Miter-Gauge Hold-Down Clamp .............. 9-29928
Hold-Down Set ............................ 9-3230
Taper Jig ................................. 9-3233
Universal Jig .............................. 9-3231
Power Tool Know How Handbook
Table Saws ............................... 9-2918
The above recommended accessories 'are current and were
available at the time this manual was printed.
27