Craftsman 113.24181 Owner's Manual page 12

If the fence does not slide easily along the bars, the pressure
of the spring can be REDUCED.
1. Loosen the screws.
2. Move spring slightly toward rear of fence . . . tighten
screw_
3.
The rip fence must be PARALLEL with the sawblade
and Miter Gauge grooves ... Move fence until it is
along side of groove. Do NOT LOCK IT. It should be
parallel to groove. If it is not;
A. Loosen the two "Hex. Head Screws."
B. Hold fence head tightly against bar ... move end
of fence so that it is parallel with groove.
C. Alternately tighten the screws.
\
\
ADJUSTING RIP SCALE POINTER
I. Turn ELEVATION crank clockwise until blade is up as
high as it will go.
IMPORTANT: BLADE must be SQUARE {90 °) to
TABLE, in order to ALIGN rip fence.
2. Position fence on right side of sawblade so that it
touches the sides of the teeth.., tighten lock knob.
3. Loosen screw holding the pointer.., adjust pointer so
that is points to "0"... tighten screw.
NOTE: If you cannot adjust pointer so that it points to
"0", loosen the screws holding the front guide bar and
move the guide bar.
\\
HEX SCRE_VS
\
'LOCK
INSTALLING BLADE GUARD
1, From amoung the loose parts, find the hardware.
2. Attach SPREADER to SPREADER SUPPORT so that
screws are all the way back in the SLOTS of SUPPORT
... hand tighten screws.
HEX HD. SO_.EW
174-zo x s/e
\
SPREADER
THUMB SCREW I_
'q//
READER SUPPORT
_I._e.._LOCKWASHER, EXT. I/4
NUT, HEX I/4
12