Lubrication; Recommended; Recommended Accessories; Miter Gauge - Craftsman 113.29570 Owner's Manual

LUBRICATION
The saw motor bearings have been packed at the factory
with proper lubricant and require no additional lubrication.
The following parts should be oiled occasionally with SAE
No. 20 or No. 30 engine oil.
!. Tilt screw threads and pivot nut. (First Clean with
Craftsman Gum & Pitch Remover.)
2. Elevation screw threads and pivot nut. (First Clean with
Craftsman Gum & Pitch Remover.)
3. Cradle bearing points.
4. Bearing points in guard assembly, miter gauge and ri_
fence.
ELEVATION SCREW
_-) /
I
!
='LEVATIONSCREW
PIVOT NUT
/
\
TILT SGREW TILT SGREW
PIVOT NUT
RECOMMENDED ACCESSORIES
ITEM CAT.NO. ITEM
Steel Legs ............................... g-22235
Steel Stand .. : ........................... 9-22214
Retractable Caster Set ..................... 9-22208
Solid Table Extension ...................... 9-29954
*7 in, Molding Head Set ............... 9-3217 9-3218
*7 in, Molding Head ........................ 9-3214
Molding/Dado Insert for 7 in
Dia. Molding or dado Head .................. 9-29933
Work Light ............................... 9-2480
CAT.NO.
Work Light ............................... 9-2481
7 in. Dia. Adjustable Dado Head ............... 9-326:3
7 in. Dia. Dado Head ....................... 9-3257
Sanding Wheel ............................ 9-2274
Miter-Gauge Stop Rods ..................... 9-29924
Miter*Gauge Hold-Down Clamp .............. 9-29928
Taper Jig ................................. 9-3233
Universal Jig ............................. ,9-3231
"'Power Tool Know How Handbook" Table Saw .. 9-291',3
The above recommended accessories are current and were
available at the time this manual was printed.
*Smaller Dia. Molding Heads cannot be used because they
do not provide adequate depth of cut.
27