Error Messages - ULTIMATE SPEED USWB 11 A2 Operation And Safety Notes

The charge current can be selected again by pressing the button
However if you want to disconnect the EV charger
Finish the charging process on the car.
„
Unplug the plug
„ 8
Wind the electric car connection cable
„
The EV charger
„ 1
is not pressed.
Voltage failure:
If there is a voltage failure, the charging process will continue automatically, once the voltage returns
(even if the RFID card is activated).
Charging process does not start:
It is normal that cars charge from a charging current of 6 A (1.3k W single phase or 4 kW three phase).
However some cars require at least 8 A so that the charging process can begin.
The set charging capacity is not reached:
The electric car defines the charging capacity, not the EV charger! Many electric cars have a maximum
limited charging capacity. The charging capacity set on the EV charger can then not be reached.
The EV charger does not charge with three phases:
A few electric cars have a built-in charge controller which only charges with single or two phases.
The car itself defines how many phases it can be charged with. Even if the EV charger is connected to
three-phase, in this case it will be charged with single or two-phases.
z Error messages
Error Meaning
ERROR 1 The temperature is too high.
(the temperature in the
housing has increased to
over 75 °C)
ERROR 3 The charging current is
too high
(the charging current is
10% higher than the set
value for 5 seconds)
ERROR 4 The charging current is
too high
(the charging current is
100% higher than the set
value for 1.5 seconds)
ERROR 5 Residual current
(residual current is
greater than 6 mA DC or
30 mA AC)
from the car and put the cover cap
7
goes into standby mode automatically after approx. 15 minutes, if the button
within 5 seconds.
2
from your car, proceed as follows:
1
on the plug
9
up without kinks.
Solution
Autorecovery of the charging process if the housing
temperature falls below 70°C.
Disconnect the device from the vehicle.
Then start the charging process again.
Disconnect the device from the vehicle.
Then start the charging process again.
Autorecovery of the charging process if there is no
residual current.
.
8
GB/IE/NI/CY/MT
2
21