ULTIMATE SPEED USWB 11 A2 Operation And Safety Notes page 10

if the connection cable is damaged;
„
if foreign objects have got into the device or you notice unusual
„
noises.
Only use the accessories supplied and recommended by the
„
manufacturer.
Do not disassemble or modify the EV charger
„
connection cable
repaired by an electrician.
Do not use the device in areas with a risk of explosion, e.g. near
„
fl ammable liquids, gases or powders.
Do not expose the device to any source of heat.
„
Do not store in places where the temperature may exceed 70 °C.
„
Do not connect the charging cable to faulty or unsuitable power
„
cables, which, for example, are not designed for the continuous
use required.
Do not step on or drive over plugs, charging cable connecting
„
cables.
Do not jam or kink charging and connection cables.
„
Do not touch plugs with wet hands.
„
When the device is not being used, always put the cover caps
„
on the plugs
The device must not be used if it is not possible to operate it
„
properly in accordance with the instructions. Ask the manufacturer,
a responsible dealer or an electrician for advice.
The device may only be connected and adjusted by an electrician.
„
CAUTION! How to avoid accidents and injuries resulting from
electric shock:
Electrical safety:
Adapters or refi t adapters must not be used. Extension cables must
„
not be used.
Do not carry the device by the cable. Protect the cable from heat,
„
oil and sharp edges.
If the cable is damaged, press the emergency stop switch immedi-
„
ately .
5
Get an electrician to check the device. A damaged charging cable
can lead to death or serious injuries. Before each use, check the
charging cable for damage (e.g. cracks). Do not use damaged
charging cables.
Do not shortcircuit the contacts on the T2 plug. This can lead to a
„
hazardous situation!
Do not put fi ngers or sharp objects into the plug contacts.
„
10
GB/IE/NI/CY/MT
and the T2 plug
7
.
8
, electric car
1
. This device must only be
8
9