LIGHTING THE BURNERS
To ignite the burner, the following instructions
are to be followed:
1.
Press in the corresponding knob and
turn counter-clockwise (fig. 18) to the full
flame position marked by the "
(fig. 17); hold the knob in until the flame
has been lit.
In the case of a mains failure light the
burner with a match or lighted taper.
2.
Wait for a few seconds after the gas
burner has been lit before letting go of
the knob (valve activation delay).
3.
Adjust the gas valve to the desired
position.
If the burner flame should go out for some
reason, the safety valve will automatically
stop the gas flow.
To re-light the burner, return the knob to
the closed "
" position,
1 minute and then repeat the lighting
procedure.
Note:
If your local gas supply makes it
difficult to light the burner with the knob set
to maximum, set the knob to minimum and
repeat the operation.
Fig. 18
24
" symbol
wait for at least