LIGHTING THE BURNERS
Models without safety cut-off valves
In order to light the burner, you must:
Models without
1 – To light one of the gas burners, hold a flame (e.g. a match) close to the top
part of the burner, push in and turn the relative knob (fig. 3b) in an anti-
clockwise direction (fig. 4), pointing the knob indicator towards the large flame
symbol
2 – Adjust the burner according to the power required.
3 – To turn it off, turn the knob towards the right, up to the safety click.
Models with electric ignition
1 – Lightly press the knob fig. 3b in anti-clockwise direction (fig. 4) up to the maxi-
mum aperture (symbol
In the case of a mains failure light the burner with a match or lighted taper.
2 – Adjust the burner according to the power required.
3 – To turn it off, turn the knob towards the right, up to the safety click.
8
electric ignition
(i.e. max. gas flow).
) , push in and hold the knob; this will light the gas.
Figure 4
:
incorporated into the knobs:
N.B. If your local gas supply makes
it difficult to light the burner with
the knob set to maximum, set the
knob to minimum and repeat the
operation.