Eclipse 1000 User Manual page 23

When operating in the 10 AMP switch position, flow rate settings above 2.0 LPM
continuous flow will automatically switch to 2.0 LPM continuous flow when the DC
Power Supply is connected.
(3) RECHARGEABLE POWER CARTRIDGE:
powered by a rechargeable Power Cartridge.
Installing the Power Cartridge:
Power Compartment. Push the Power Cartridge into the Power Compartment until it
is secure and flush with the back of the system. When the Power Cartridge is properly
inserted and the ECLIPSE is
the Control Panel. (If you DO NOT have a Power Cartridge installed, the Status Gauge
will not light up).
To remove the Power Cartridge, push up on the latch on the Power Cartridge.
The Power Cartridge will slide out so that you can grasp it for removal.
Power Cartridge Capacity:
panel. A variety of factors, such as flow rate and Pulse or Continuous Flow Mode
operation determine the duration of operating time. The following table provides
estimates of amount of time that the ECLIPSE can operate
on a fully charged Power Cartridge given certain
flow rates and operating conditions.
Latch
The ECLIPSE system can also be
Align the Power Cartridge so that it will slide into the
, the Power Cartridge Status Gauge will appear on
ON
The capacity of the Power Cartridge is lit up on the control
Power Cartridge
Model 1000 User Manual
ECLIPSE TM Model 1000 User Manual
| 21