Eclipse 1000 User Manual page 16

Understanding the Controls and Front Panel (continued)
Troubleshooting section for the proper response. A flashing yellow
indicates a medium priority alert. Prompt response is needed to deal
with a condition. Refer to the Troubleshooting section.
ALARM (Red) Indicator - High Priority Alarms:
Indicates a high priority alarm condition. Immediate response is
necessary to deal with the condition. Refer to the Troubleshooting
section and contact your dealer/provider.
Buzzer:
condition of the unit, either a warning or failure, and to confirm a valid
key press.
Flow Rate Setting Indicator (Green):
control panel. Your dealer/provider will set up your prescribed flow
rates for your Continuous Flow Mode (LPM) and your Pulse Flow
settings, if pulse flow has been prescribed. DO NOT change these
settings unless it is under the order of your physician. Each time you
turn the unit on, the last flow mode and flow setting will be used.
Power Cartridge Status Gauge:
remaining in the Power Cartridge. When the Power Cartridge is fully
charged all 10 bars are illuminated. Each bar represents approximately
10% of the total Power Cartridge charge. When the Power Cartridge is
being charged, the charge indicator bars will blink in a waterfall fashion.
If the Power Cartridge is not installed, or if it is improperly installed, the
Status Gauge will not light.
External Power Present Indicator:
properly plugged in using the AC or DC Power Supply, this indicator
will appear on the Control Panel.
14 | ECLIPSE
TM Model 1000 User Manual
An audible alarm (or buzzer) is used to alert you of the
This is the main focus on your
This indicator displays the charge
When the ECLIPSE system is