Selec-Terrain - If Equipped; Mode Selection Guide; Power Steering - Jeep Compass 2023 Owner's Manual

Table of Contents

Advertisement

Active Drive Control — If Equipped
The Power Transfer Unit (PTU) is locked to ensure
immediate availability of torque to the rear drive axles.
This feature is selectable in AUTO mode and automatic in
the other driving mode. 4WD LOCK can be enabled by the
following ways:
 When the 4WD LOCK button is pushed.
 When the Selec-Terrain switch is moved from AUTO to
any other off-road modes.
Active Drive With Low Control — (Trailhawk Models Only)
The 4WD LOW mode helps to improve the off-road
performance in all modes. To enable 4WD LOW, see the
following:
Enabling 4WD LOW
With the vehicle stationary, the ignition in the ON/RUN
position or with the engine running, shift the transmission
into NEUTRAL and push the 4WD LOW button once. The
instrument cluster will display the message "4WD LOW"
once the shift is complete.
NOTE:
 Both LOCK and LOW LED lights will blink and then
become active on the buttons until the shift is
complete.
 The instrument cluster display will illuminate the
4WD LOW icon.
Disabling 4WD LOW
To disable the 4WD LOW mode, the vehicle must be
stationary and the transmission shifted into NEUTRAL.
Push the 4WD LOW button once.
SELEC-TERRAIN — IF EQUIPPED
Selec-Terrain combines the capabilities of the vehicle
control systems, along with driver input, to provide the
best performance for all terrains.
M
S
G
ODE
ELECTION
UIDE
Selec-Terrain Switch
 AUTO: This four-wheel drive operation is a continuous
operation, is fully automatic and can be used on and
off road. This mode balances traction to ensure
maneuverability and acceleration improvement
compared to a vehicle with two wheel drive. This mode
also reduces fuel consumption, since it allows the
disconnect of the drive shaft where conditions permit.
 SNOW: This mode allows you to have greater stability
under conditions of bad weather. For use on and off
road on surfaces with poor traction, such as roads
covered with snow. When in SNOW mode (depending
STARTING AND OPERATING
on certain operating conditions), the transmission may
use SECOND gear (rather than FIRST gear) during
launches, to minimize wheel slippage.
 SAND/MUD: For off-road driving or use on surfaces
with poor traction, such as dry sand and roads covered
by mud or wet grass. The transmission is set to provide
maximum traction.
 ROCK: (Trailhawk only): This mode is only available in
4WD LOW range. The device sets the vehicle to maxi-
mize traction and allow the highest steering capacity
for off-road surfaces. This mode gives you the
maximum performance off-road. Use for low speed
obstacles such as large rocks, deep ruts, etc.
NOTE:
 ROCK mode is only available on the vehicles equipped
with the Off-Road package.
 Activate the Hill Descent Control for steep downhill
control
page 166.
Ú

POWER STEERING

The electric power steering system will provide increased
vehicle response and ease of maneuverability. The
electric power steering system adapts to different driving
conditions.
WARNING!
Continued operation with reduced assist could pose a
safety risk to yourself and others. Service should be
obtained as soon as possible.
101
4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents