Heated Steering Wheel; If Equipped; Driver Memory Settings - If Equipped - Jeep Compass 2022 Owner's Manual

H S W
EATED TEERING HEEL
I E
F QUIPPED
The steering wheel contains a heating
element that helps warm your hands in
cold weather. The heated steering wheel
has only one temperature setting. Once
the heated steering wheel has been turned on, it
will stay on until the operator turns it off. The
heated steering wheel may not turn on when it is
already warm.
The heated steering wheel control button is
located within the Uconnect system. You can gain
access to the control button through the climate
screen or the controls screen.
Push the heated steering wheel button once to

turn the heating element on.
Push the heated steering wheel button a second

time to turn the heating element off.
NOTE:
The engine must be running for the heated
steering wheel to operate.
For information on use with the Remote Start
system, see Ú page 20.
—
Persons who are unable to feel pain to the

skin because of advanced age, chronic illness,
diabetes, spinal cord injury, medication,
alcohol use, exhaustion, or other physical
conditions must exercise care when using the
steering wheel heater. It may cause burns
even at low temperatures, especially if used
for long periods.
Do not place anything on the steering wheel

that insulates against heat, such as a blanket
or steering wheel covers of any type and mate-
rial. This may cause the steering wheel heater
to overheat.
DRIVER MEMORY SETTINGS — IF EQUIPPED
This feature allows the driver to save up to two
different memory profiles for easy recall through a
memory switch. Each memory profile saves
desired position settings for the following features:
Driver seat position

Easy Entry/Exit seat (if equipped)

A set of desired radio station presets

WARNING!
GETTING TO KNOW YOUR VEHICLE
NOTE:
Your vehicle is equipped with two key fobs, each
can be linked to either memory position 1 or 2.
The memory setting switch is located on the
driver's door trim panel. The switch consists of
three buttons:
The set (S) button, which is used to activate the

memory save function.
The (1) and (2) buttons which are used to recall

either of two saved memory profiles.
Memory Switches
27
2