Table of Contents
Advertisement
Figure 183. Removing the left control panel
Installing the left control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the drive backplane
4. If installed,
remove the air shroud
5.
Remove the cooling fan cage
6.
Remove the side wall
Steps
1. Align and slide the left control panel in the slot on the system.
2. Route the left control panel cable through the side wall of the system.
3. Align and slide the left control panel cable cover in the slot on the system.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
4. Connect the left control panel cable to the connector on the system board .
5. Using the Phillips #1 screwdriver, tighten the screws to secure the left control panel and the cable cover to the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Safety
Before working inside your
cover.
or
remove the GPU air
assembly.
bracket.
instructions.
system.
shroud.
Installing and removing system components
185
Advertisement
Table of Contents
