Table of Contents
Advertisement
5. Using the Phillips #1 screwdriver, tighten the screws that secure the right control panel and the cable cover to the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 182. Installing the right control panel
Removing the left control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the drive backplane
4. If installed,
remove the air shroud
5.
Remove the cooling fan cage
6.
Remove the side wall
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secure the left control panel and the cable cover to the system.
2. Remove the cable cover away from the system.
3. Disconnect the control panel cable from the connector on the system board.
4. Holding the cable, slide the left control panel out of the system.
NOTE:
Observe the routing of the cable as you remove the left control panel from the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
184
Installing and removing system components
Safety
Before working inside your
cover.
or
remove the GPU air
assembly.
bracket.
instructions.
system.
shroud.
Advertisement
Table of Contents
