Programming Vacation Periods (Special Times-Of-Use) - Samson TROVIS 5578-E Translation Of Original Instructions

5.2.5

Programming vacation periods (special times-of-use)

The system runs constantly in reduced mode during vacation periods. A maximum of ten va-
cation periods can be entered. Each vacation period can be separately assigned to the heat-
ing circuits HC1, HC2, HC3 and DHW circuit or to all control circuits.
Note
If a vacation period is programmed to apply to all control circuits, it also applies to control
circuits HC11, HC12 and HC13.
Parameters
Vacation period
KA 5578-E EN
After programming all public holidays:
q Select 'Back'.
¼ Exit the public holiday setting.
Turn the rotary switch back to
Note
Public holidays that are not assigned to a specific date
should be deleted by the end of the year so that they are not
carried on into the following year.
WE Value range
--.-- - --.-- 01.01 to 31.12
Turn the rotary switch to
timer for the first control circuit is now selected.
q Select 'Vacations'.
(operating level).
(special times-of-use). The party
Operation
17