1.6.1 Entering vacation periods
When the switch position Automatic operation with switchover between day mode and night
mode is selected, night set points (reduced set points) are used by the controller. When the
switch position Automatic operation with switchover between day mode and stand-by mode
is selected, the system is switched off. The frost protection function remains active.
A maximum of 10 vacation periods may be entered.
Parameter
Vacation periods
Proceed as follows:
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
To enter additional vacations, re-select – – – – (between 31.12 and 01.01) and repeat the steps
in the fields highlighted in gray.
Exit the parameter level.
Return to the operating level.
Note!
In systems Anl 1 to 3 with integrated DHW heating (Co5 -> Fb13 = ON), the vacations entered
also apply to the DHW heating with the setting Co4 -> Fb10 = ON.
Switch to the parameter and configuration level.
Display: PA1
Select PA5 parameter level.
Open PA5 parameter level. Display: Controller time
15
16
17
18
19
20
21
22
23
24
Select datapoint for vacation period. Display:
Open data point for vacation period. Display: START
If applicable, select – – – – .
Activate editing mode for vacation periods.
Set start date of vacation period.
Confirm start date of the vacation period.
Display: STOP
Set end of vacation period.
Confirm end of the vacation period.
WE
Parameter level / Range of value
–
PA5 / 01.01 to 31.12
blinks.
Operation
15
EB 5474 EN