Setting The Party Timer (Special Time-Of-Use) - Samson TROVIS 5578-E Translation Of Original Instructions

5.2.3

Setting the party timer (special time-of-use)

Rated operation in the corresponding control circuit (HC1, HC2, HC3 or DHW) is started or
continued for the time period set in the party mode. When the party timer has elapsed, the
party timer returns to --:--.
Parameters
HC1 party timer
HC2 party timer
HC3 party timer
DHW party timer
KA 5578-E EN
WE
--:-- h
--:-- h
--:-- h
--:-- h
Turn the rotary switch to
timer for the first control circuit is now selected.
q Set time for party mode of another control circuit, if re-
quired:
– Heating circuit HC2
– Heating circuit HC3
– DHW heating
Î Only those control circuits are available for selection
which can be controlled by the selected system.
¼ Activate editing mode for the party timer. The party tim-
er is now in the editing mode (inverted display).
q Extend day operation as required.
(in steps of 15 minutes)
¼ Confirm setting.
After setting the party timer:
Turn the rotary switch back to
Note
Party timer runs down in steps of 15 minutes.
Value range
0 to 48 h; in steps of 15 minutes
0 to 48 h; in steps of 15 minutes
0 to 48 h; in steps of 15 minutes
0 to 48 h; in steps of 15 minutes
(special times-of-use). The party
(operating level).
Operation
15