Table of Contents
Advertisement
8.1 Communication Instruction
Operand
Settings
S1+1
Specification
S2
of a
destination unit
Specification
n
of a
destination unit
Specification
D
of a master
unit
(Note 1)
To [S1], the following specification should be applied. The specification method differs depending on
word transfer and bit transfer.
[S1]：
[S1]：
Transfer in
bit units
(Note 2)
To [S1+1], the following specification should be applied.
COM port selection
(upper four bits)
Port no.
■
Specifying [S2] as the starting address of the source data area
Specify "0" for [S2] as the device No. Specify the memory area of a destination unit that stores
sent data, by combining [S2] (type) and [n] (address).
Example 1: [S2]: DT0, [n]: K100
↓
8-6
Word transfer: Specify the number of send words.
Bit transfer: Specify the bit number of a master unit and that of a
destination unit.
Specify the COM port No. of a master unit and the unit number of a
destination unit.
Specify the source data area of a destination unit. (Device No.
is fixed to "0")
Specify the starting address of the device in the source data
area of a destination unit.
Specify the device starting address of the receive data storage
area in the master unit.
H0
Transfer in
word units
H8
Destination bit No.
(H0 to HF)
HF
COM0
Specify the number of send words
H001 to H1FD (1 to 509 words)
H0 (fixed)
Destination unit bit No.
(H0 to HF)
H1
COM1
H2
H3
COM2
COM3
WUME-FPXHCOMG-02
Setting
range
(Note 2)
H0 to
HFFFF
H4
COM4
Advertisement
Table of Contents
