8.1 Communication Instruction
Operand
Settings
Specification
D
of a
destination unit
Specification
n
of a
destination unit
(Note 1)
To [S1], the following specification should be applied. The specification method differs depending on
word transfer and bit transfer.
[S1]:
[S1]:
Transfer in
bit units
(Note 2)
To [S1+1], the following specification should be applied.
COM port selection
(upper four bits)
Port no.
■
Specifying the storage area of a destination unit by using [D] and [n]
Specify "0" for [D] as the device No.
Specify the memory area of a destination unit that stores sent data, by combining [D] (type) and
[n] (address).
Example 1: [D]: DT0, [n]: K100
↓
DT100
Example 2: [D]: DT0, [n]: HFFF0
↓
DT65520
8-4
Specify the area type of a destination unit that stores send
data. The number is specified at 0.
Specify the starting address of a destination unit that stores
send data.
H0
Specify the number of send words
Transfer in
H001 to H1FB (1 to 507 words)
word units
H8
Destination bit No.
(H0 to HF)
HF
COM0
H0 (fixed)
Master unit bit No.
(H0 to HF)
H1
H2
COM1
COM2
Setting range
H0 to HFFFF
H3
H4
COM3
COM4
WUME-FPXHCOMG-02