Supermicro X6DVL-EG2 User Manual page 82

X6DVL-EG2 User's Manual
Checkpoint Code Description
60h The DMA page register test passed. Performing the DMA Controller
1 base register test next.
62h The DMA controller 1 base register test passed. Performing the DMA
controller 2 base register test next.
65h The DMA controller 2 base register test passed. Programming DMA
controllers 1 and 2 next.
66h Completed programming DMA controllers 1 and 2. Initializing the 8259
interrupt controller next.
67h Completed 8259 interrupt controller initialization.
7Fh Extended NMI source enabling is in progress.
80h The keyboard test has started. Clearing the output buffer and
checking for stuck keys. Issuing the keyboard reset command next.
81h A keyboard reset error or stuck key was found. Issuing the keyboard
controller interface test command next.
82h The keyboard controller interface test completed. Writing the com-
mand byte and initializing the circular buffer next.
83h The command byte was written and global data initialization has
completed. Checking for a locked key next.
84h Locked key checking is over. Checking for a memory size mismatch
with CMOS RAM data next.
85h The memory size check is done. Displaying a soft error and checking
for a password or bypassing WINBIOS Setup next.
86h The password was checked. Performing any required programming
before WINBIOS Setup next.
87h The programming before WINBIOS Setup has completed.
Uncompressing the WINBIOS Setup code and executing the
AMIBIOS Setup or WINBIOS Setup utility next.
88h Returned from WINBIOS Setup and cleared the screen. Performing
any necessary programming after WINBIOS Setup next.
89h The programming after WINBIOS Setup has completed. Displaying the
power on screen message next.
8Bh The first screen message has been displayed. The <WAIT...>
message is displayed. Performing the PS/2 mouse check and
extended BIOS data area allocation check next.
8Ch Programming the WINBIOS Setup options next.
8Dh The WINBIOS Setup options are programmed. Resetting the hard disk
controller next.
8Fh The hard disk controller has been reset. Configuring the floppy drive
controller next.
91h The floppy drive controller has been configured. Configuring the hard
disk drive controller next.
B-6