The Stapling Position Is Not Correct; Output Does Not Collect Neatly In The Output Tray Of The Finisher; Stapled Output Does Not Collect Neatly - Sharp MX-B401 Operation Manual

Problem
Stapling does not take
place.
The stapling position
is not correct.
Output does not
collect neatly in the
output tray of the
finisher.
Stapled output does
not collect neatly.
Point to check
Is a different width of paper mixed in?
Are there more sheets than can be
stapled at once?
Is a paper size that cannot be stapled
included in the print job?
Is the paper type setting of the tray
selected in the printer driver set to a
paper type that cannot be stapled?
Have functions been disabled by the
administrator?
Is the stapling position set correctly?
Is the paper curled?
Is the paper curled?
Stapling is not possible when paper of different widths
are mixed together. To perform mixed size stapling, use
paper of the same width. When copying, select [Mixed
Size Original] in the special modes.
For the maximum number of sheets that can be stapled,
see "SPECIFICATIONS" in the Maintenance & Safety
Guide.
For the paper sizes that can be stapled, see
"SPECIFICATIONS" in the Maintenance & Safety
Guide.
Check the paper type settings in the machine and select
a tray that has paper that can be used for stapling*.
Click the [Tray Status] button in "Paper Selection" on
the [Paper] tab of the printer properties window and
check the paper type setting of each tray.
* Stapling is not possible on labels, transparency film, or
envelopes. In addition, if "Disable Staple" is selected in
the user type, stapling will not be possible.
Some functions may have been disabled in the system
settings (administrator). Check with your administrator.
Check the stapling position setting.
☞
2. COPIER "OUTPUT" (page 2-32)
It may help to turn the paper over in the paper tray.
It may help to turn the paper over in the paper tray.
8-36
TROUBLESHOOTING
Solution
Contents