Observe And Obey - Terex Genie GS-1932 XH Operator's Manual

Eighth Edition • Second Printing
Lift Tools Pipe Cradle
Instructions
The Lift Tools Pipe Cradle assembly consists of
2 pipe cradles positioned at either side of the
platform and mounted to the guardrails with
U-bolts.
1 strap
2 bolt, 3/8-16 x 2"
3 cradle
4 edge trim
5 cap
6 nut, 3/8-16
7 strap brace
8 bolt, 1/4-20 x 3.25"
9 nut, 1/4-20
10 pin bracket
11 carriage bolt, 3/8-16 x 2.25"
12 spacer
13 foot mount
14 rubber bumper
15 large pipe cradle
Part No. 1296776GT

Observe and Obey:


Lift Tools Pipe Cradle must be mounted on the
inside of the platform.

Lift Tools Pipe Cradles cannot be used with
any other option, except Lift Tools Work Tray
and Lift Guard Contact Alarm.

Lift Tools Pipe Cradles must not obstruct the
platform controls or the platform entrance.

Lift Tools Pipe Cradle assembly is restricted to
indoor use only.

Platform is restricted to one person when Lift
Tools Pipe Cradles option is in use.

The bottom foot mount of the Lift Tools Pipe
Cradles tube must rest on the platform
toe-board.

Be sure the Lift Tools Pipe Cradles is secured
to the platform.
Lift Tools Pipe Cradle Installation
1 Slide the railing mounting brackets until the
rubber bumper lands on the railings.
2 Tighten the bolts on foot mount bracket.
3 Tighten the bolts on railing mounting brackets.
™ ™
GS -30 • GS -32 • GS
Operating Instructions
™
-46
Operator's Manual
79