Storage; Cleaning And Storage - Toro Z Master Professional 7000 Series Operator's Manual

Storage

Cleaning and Storage

1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to the Off position.
Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine and hydraulic system. Clean dirt and chaff from
the outside of the engine cylinder head fins and blower
housing.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the control panel, engine, hydraulic pumps,
and motors.
3. Check the brake; refer to
(page 50).
Service the air cleaner; refer to
(page 37).
4. Grease the machine; refer to
5. Change the crankcase oil; refer to
Oil (page 38).
Check the tire pressure; refer to
Maintenance (page
6. Change the hydraulic filter; refer to
Maintenance (page
7. Charge the battery; refer to
Maintenance (page
8. Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with
a garden hose.
Note: Run the machine with the PTO engaged and
the engine at high idle for 2 to 5 minutes after washing.
9. Check the condition of the blades; refer to
the Cutting Blades (page
Prepare the machine for storage when non-use occurs
over 30 days. Prepare the machine for storage as
follows:
A. Add a petroleum based stabilizer/conditioner to
fuel in the tank. Follow mixing instructions from
the stabilizer manufacturer. Do not use an alcohol
based stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and used at
all times.
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
C. Stop the engine, allow it to cool, and drain the fuel
tank; refer to Fuel System Maintenance (page
Adjusting the Parking Brake
Engine Maintenance
Lubrication (page
Servicing the Engine
Drive System
45).
Hydraulic System
55).
Electrical System
43).
Servicing
60).
D. Restart the engine and run it until it stops.
E. Dispose of fuel properly. Recycle as per local
codes.
Important: Do not store
stabilizer/conditioned fuel over 90 days.
10. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
11. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
12. Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it
out of reach of children or other unauthorized users.
Cover the machine to protect it and keep it clean.
35).
41).
64