Toro Z Master Professional 7000 Series Operator's Manual page 44

Figure 57
1. Battery
2. Hydraulic tank
3. Bolts
Installing the Battery
1. Position the battery in the tray with the terminal posts
opposite from the hydraulic tank
2. First, install the positive (red) battery cable to positive
(+) battery terminal.
3. Then install the negative battery cable and ground wire
to the negative (-) battery terminal.
4. Secure the cables with 2 bolts (1/4 x 3/4 inch),
2 washers (1/4 inch), and 2 locknuts (1/4 inch)
56).
5. Slide the red terminal boot onto the positive (red)
battery post.
6. Secure battery with J-bolts, hold down clamp, 2 washers
(1/4 inch), and 2 wing nuts (1/4 inch)
4. Wing nut
5. Right side fuel tank
(Figure 57).
(Figure
(Figure 57).
Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from battery.
Important: Always keep the battery fully charged
(1.265 specific gravity). This is especially important to
prevent battery damage when the temperature is below
32°F (0°C).
1. Make sure that the filler caps are installed in the battery.
Charge the battery for 10 to 15 minutes at 25 to 30
amps or 30 minutes at 10 amps.
2. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts
3. Install the battery in the machine and connect the
battery cables, refer to
Note: Do not run the machine with the battery
disconnected, electrical damage may occur.
1. Positive battery post
2. Negative battery post
44
(Figure 58).
Installing the Battery (page
Figure 58
3. Red (+) charger lead
4. Black (-) charger lead
44).