Using The Rollover Protection System (Rops) - Toro Z Master Professional 7000 Series Operator's Manual

1. Left side fuel tank
Using the Rollover Protection
System (ROPS)
WARNING
To avoid injury or death from rollover: keep the
roll bar in the raised locked position and use the
seat belt.
Ensure that the rear part of the seat is secured with
the seat latch.
WARNING
There is no rollover protection when the roll bar is
in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar is
in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance permits.
• Check carefully for overhead clearances (i.e.
branches, doorways, electrical wires) before
driving under any objects and do not contact
them.
Figure 7
2. Fuel-selector valve
Important: Lower the roll bar only when absolutely
necessary.
1. Remove the hairpin cotter pins and remove the 2 pins
(Figure 9).
2. Lower the roll bar to the down position. There are 2
down positions. See
3. Install the 2 pins and secure them with the hairpin
cotter pins (Figure
1. Full down position
Important: Ensure that the rear part of the seat is
secured with the seat latch.
4. To raise the roll bar, remove the hairpin cotter pin and
remove the 2 pins
5. Raise the roll bar to the upright position and install the
2 pins and secure them with the hairpin cotter pins
(Figure 9).
Important: Always use the seat belt with the roll
bar in the raised position.
19
Figure 8 for the positions.
9).
Figure 8
2. Down position with bagger
installed
(Figure 9).