Negative Code File Programming
Use the following procedure for negative code file programming:
Negative code/Override status
You can program the negative code and its override status.
Procedure
Select a negative code and press
(Or enter the corresponding code.)
To delete a negative code, proceed as follows:
Program each item as follows:
• NEGATIVE# (Use the numeric entry method)
Negative code (max. 16 digits)
• OVERRIDE (Use the selective entry method)
Negative code checking can be overridden in compliance with
programmed override status.
(Override/access operation:
(Not to override:
REG&MGR:
MGR ONLY:
INHIBIT:
NOTE
• You can create a new code by entering the code, then pressing the
.
ENTER
key.
Enter the code or move the cursor to the code, and then press the DEL
key.
— 223 —
)
)
CANCEL
Available to the manager and servers/cashiers.
The message "ACCESS" is displayed.
Only availanle to the manager.
The message "CALL MGR" is displayed.
The override operation is inhibited.
The message "NOT ACCEPT" is displayed.
ENTER