Table of Contents
Advertisement
Communication Gateway Module (CGM) Kits
F
. 20: CGM CAN Connections
IG
CGM Kits
Part Number Description
25E426
CGM Kit, Ethernetip
25E427
CGM Kit, DeviceNet
25E428
CGM Kit, PROFINET
25E429
CGM Kit, PROFIBUS
Installing a CGM Kit
All electrical wiring must be done by a qualified elec-
trician and comply with all local codes and regulations
1. Follow the Pressure Relief Procedure on page 16.
2. Verify the power is off to the system.
3. Mount the CGM near the pump or near the integra-
tion point.
3A6586A
CAN Port 2
CAN Port 1
4. Drill the mounting holes using the mounting hole
dimensions shown in Figure 21.
#10-32 UNF
(M5 x 0.8)
3.25 in.
(82.6 mm)
F
. 21: CGM Mounting Holes
IG
5. Remove the access cover from the CGM (U).
Loosen the two screws (T) and remove the CGM (R)
from the base (S) as shown in Figure 22.
T
S
F
. 22: Disassembling the CGM
IG
6. Using the four 10-32 mounting screws included with
the kit, mount the base (S) in the holes you drilled.
7. Reattach the CGM (R) on the base (S) with the two
screws (T) that were removed in step 5.
8. Reattach the access cover (U).
Kits and Accessories
2.75 in.
(69.9 mm)
R
U
29
Advertisement
Table of Contents
