4. Enter the Edit screen for that pump by pressing the
soft key next to the
5. Press the soft key next to the Pressure Mode
icon.
6. Enter 100 psi (0.69 MPa, 6.9 bar) as the pressure.
7. Press the soft key next to the Pump On/Off
icon to turn on the pump.
8. Adjust pressure as necessary.
9. Hold a metal part of the dispense valve firmly to the
side of a grounded metal pail.
10. Open the dispense valve and flush the system until
clear solvent flows from the gun/valve.
11. Exit the Edit screen by pressing the soft key next to
the
icon.
12. If you have multiple pumps connected, repeat steps
3 through 11 for each pump you want to flush.
Follow the Pressure Relief Procedure on page 16.
3A6586A
icon.
Setup
15