Table of Contents
Advertisement
• VLAN ID
• L2 Priority
• DSCP
• Adding a new policy
Port Policies Configuration
Every port may advertise a unique set of network policies or different attributes for the same network policies, based on the
authenticated user identity or port configuration.
Object
• Port
• Policy ID
Buttons
: Click to apply changes
:
Click to undo any changes made locally and revert to previously saved values.
4.3.8.5 LLDP-MED Neighbor
This page provides a status overview for all LLDP-MED neighbors. The displayed table contains a row for each port on which
an LLDP neighbor is detected. The LLDP-MED Neighbor Information screen in
following information:
User's Manual of GS-5220 LCD Series Managed Switch
fields are ignored and only the DSCP value has relevance.
Tagged indicates that the device is using the IEEE 802.1Q tagged
frame format, and that both the VLAN ID and the Layer 2 priority
values are being used, as well as the DSCP value. The tagged format
includes an additional field, known as the tag header. The tagged
frame format also includes priority tagged frames as defined by IEEE
802.1Q-2003.
VLAN identifier (VID) for the port as defined in IEEE 802.1Q-2003
L2 Priority is the Layer 2 priority to be used for the specified application type. L2
Priority may specify one of eight priority levels (0 through 7), as defined by IEEE
802.1D-2004. A value of 0 represents use of the default priority as defined in
IEEE 802.1D-2004.
DSCP value to be used to provide Diffserv node behavior for the specified
application type as defined in IETF RFC 2474. DSCP may contain one of 64
code point values (0 through 63). A value of 0 represents use of the default
DSCP value as defined in RFC 2475.
Click
Tag, VLAN ID, L2 Priority and DSCP for the new policy. Click "Save".
The number of policies supported is 32
Description
The port number for which the configuration applies.
The set of policies that shall apply for a given port. The set of policies is selected
by checkmarking the checkboxes that corresponds to the policies
218
to add a new policy. Specify the Application type,
Figure 4-3-8-4
appears. The columns hold the
Advertisement
Table of Contents
