Restoring Priorities In A Scan List; Using The Hang Up Box (Hub); Call Alert Paging - Motorola APX 4500Li User Manual

This change remains in effect until scan is turned off. Scan
then reverts to the preprogrammed (original) setting.
1 Press the Menu Select button directly below DYNP to
change the priority of a non-priority channel in the
scan list to Priority-Two.
2 Press
momentarily to exit the scan list and
resume scanning.

Restoring Priorities in a Scan List

To restore the original channel priorities in a scan
list, perform one of the following actions:
• Turn scan off, and then on.
• Change channels.
• Turn off the radio, and then turn it back on.

Using the Hang Up Box (HUB)

To temporarily suspend Scan Mode operation,
remove the control head from the Hang Up Box
(HUB).
You are allowed to use the control head while scan
is suspended. However, Priority Member scanning is
not suspended. This feature applies to all Scan Lists
and Scan Types. Scan is resumed once the control
head is returned to the holding clip and the
preprogrammed hang time has elapsed.
NOTICE:
Priority Scan List members are continuously
scanned only when the Scan List,
Designated Tx Member field is set to
"Talkback" in the radio programming.
Otherwise, all scan mode operation is
suspended.

Call Alert Paging

This feature allows your radio to work like a pager.
If other users are away from their radios or if they are
unable to hear their radios, you can send them an
individual call alert page. You can also verify if a radio is
active on the system.
Depending on how your radio is programmed, if there is no
answer after the maximum ring time or when you press the
PTT button for an Enhanced Private Call, the radio
automatically sends a call alert page.
English
97