Sending An Emergency Alarm With Emergency Call; Sending An Emergency Alarm And Call With Hot Mic - Motorola APX 4500Li User Manual

English
Sending an Emergency Alarm with
Emergency Call
This feature gives your radio priority access on a channel
for conventional system, and to a talkgroup for trunking
system.
If the radio has both emergency call and alarm features
enabled, it automatically proceeds to the call mode after
the alarm is acknowledged.
1 Press the preprogrammed Emergency button.
The display alternates Emergency and the home
display. A high-pitched tone sounds, indicating that
the trunked system central controller has received
the alarm. A dispatcher acknowledgment (four high-
pitched tones) follows, accompanied by an Ack
received display.
2 Hold the radio vertically 1 to 2 inches (2.5 to 5.0 cm)
from your mouth.
3 Press and hold the PTT button. Speak clearly into
the microphone.
106
4 Release the PTT button to end the transmission and
wait for a response from the dispatcher.
5 To exit Emergency Call, press and hold the
preprogrammed Emergency button for about a
second.
Turning off the radio also cancels the emergency
state.
Sending An Emergency Alarm and Call
with Hot Mic
This feature allows you to send an Emergency Alarm and
Call with hot mic to a group of radios.
Your radio must be programmed for this type of operation.
Follow the procedure to send Emergency Alarms and Call
with hot mic on your radio.
1 Press the preprogrammed Emergency button.
If successful, the display shows Emergency on the
current zone and channel. A tone sounds and the
LED blinks red momentarily.