12 SERVICE WORK ON THE CHASSIS
12.12
70
V01792-10
Installing the lower triple clamp
B01604-10
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
M8
brake caliper
–
Mount the cable ties.
–
Position the brake line, the wiring harness, and the clamp.
Mount and tighten screws
Finishing work
–
Mount the handlebar cushion.
–
Install front fender. (
p. 75)
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check that the wiring harness, throttle cables, and brake and
clutch lines can move freely and are routed correctly.
–
Check the steering head bearing play. (
–
Remove the motorcycle from the lift stand. (
–
Check the headlight setting. (
(All Six Days models)
Main work
–
Clean the bearing and sealing elements, check for damage,
and grease.
High viscosity grease (
–
Position the lower triple clamp with the steering stem. Mount
upper steering head bearing.
–
Check whether upper steering head seal
tioned.
–
2
Mount protective ring
25 Nm (18.4 lbf ft)
Loctite
bk
.
(
p. 114)
p. 128)
p. 72)
p. 63)
p. 130)
p. 170)
1
is correctly posi-
3
and O-ring
.
9
.
®
243™