15 ELECTRICAL SYSTEM
15.12
15.13
118
V00371-10
V00372-10
Diagnostics connector
H00933-12
OCU
W00331-10
–
Using a coin, turn protection cap
wise and take it off.
–
Remove combination instrument battery
–
Insert the combination instrument with the label facing
upward.
Combination instrument battery (CR 2430) (
–
Check the O-ring of the protection cap for correct seating.
–
2
Position protection cap
using a coin.
–
Press any button on the combination instrument.
The combination instrument is activated.
–
Position the combination instrument in the holder.
–
Mount and tighten the screws with washers.
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Set kilometers or miles. (
–
Set the combination instrument. (
–
Set the clock. (
p. 27)
1
Diagnostics connector
is located under the seat.
1
OCU
is located under the seat.
The OCU replaces the electronic fuses and relays.
All outputs are switched independently of the signals of the volt-
age regulator and ECU.
The outputs are deactivated individually in the event of overcur-
rent.
This enables easy error detection because the status of each out-
put is indicated via LED lights.
The OCU monitors the electronics system completely indepen-
dently.
As soon as an indicated error is rectified, the status light of the
OCU changes from red to green.
2
all the way counterclock-
3
.
p. 148)
and turn all the way clockwise
p. 115)
p. 116)
p. 26)
p. 27)