F11 Display Resolution Setting - SMC Networks ISE79S L2 Series Operation Manual

■[F11] Display resolution setting
This function is to change the pressure display resolution.
The flicker of the display can be reduced.
<Operation>
Press the UP or DOWN button in function selection mode to display [F11].
Display resolution setting
Press the UP or DOWN button to select the display resolution.
Press the SET button to set.
: It may not be possible to change the resolution depending on the unit of pressure selected.
The units that allow display resolution to be selected are [MPa], [kgf/cm
2
(The units [kgf/cm ], [bar] and [psi] can only be set when using a product with units selection function.)
Page 28 [F 0] Display units, switch output specifications and diagnostic information selection function
Press the SET button.
[F11] Display resolution setting completed
-45-
Move on to display resolution setting.
Return to function selection mode.
2
], [bar] and [psi].
No.PS※※-OMY0007-B