F11 Display Resolution - SMC Networks ZL6 Series Operation Manual

■[F11] Display resolution
This function is used to change the pressure display resolution.
This can be used to prevent the digits from flickering on the display.
<Operation>
Press the or button in function selection mode to display [F11].
Setting of display resolution
or
Press the button to select display resolution.
: It may not be possible to change the resolution depending on the unit of pressure selected..
The units that allow display resolution to be selected are MPa, kPa, kgf/cm
2
(The units kgf/cm , bar, psi and inHg can only be set when using a product with unit conversion function.)
[F 0] Unit selection function on page 23.
Press the button.
Press the button to set.
Setting of [F11] Display resolution completed.
Move on to setting of display resolution.
Return to function selection mode.
2
, psi and inHg.
-32-
NO.ZL3-OM00701-A