System Operation; Clear Port Names; Restore Default Values; Reset On Exit - ATEN RCM Series User Manual

KVM over IP User Manual

System Operation

The System Operation page lets you restore certain configuration changes that
were made to the RCM Series of KVM Over IP Switch back to their original
factory default values.
The functions performed on this page are as follows:

Clear Port Names:

Clicking this button removes names that have been assigned to the ports

Restore Default Values:

Clicking this button undoes all Customization page changes that have been
made to the RCM Series of KVM Over IP Switch (except for the Port Names),
as well as the Network Transfer Rate (on the Network page), and returns the
parameters to the original factory default settings.

Reset on exit:

Place a check here and click Apply to have the RCM Series of KVM Over IP
Switch reset itself and implement all the new settings when you log out.
(Following the reset, wait approximately 30 to 60 seconds before logging back
in.)
If you change the switch's IP Address (see Network, page 164), the checkbox
is automatically checked and the KVM switch will reset when you log out. If
you clear the check mark before logging out, the changed IP settings will be
ignored and the original IP address settings will remain in effect.
Note: Even though the changed IP settings are ignored, they still remain in the
network settings fields. Which means that the next time you open this
page the Reset on exit checkbox will automatically be enabled, and
when the switch resets, the new IP settings that you thought you
discarded will become the ones used by the switch. To avoid this
problem, you should go back to the network settings page and be sure
that the IP settings that appear in the fields are the ones you want to use.
212