Step 2: Up And Running; Plug And Play - Juniper ACX7100 Quick Start Manual

WARNING: Ensure that the power cord does not block access to router components or drape
where people can trip on it.
11. If the AC power source outlet has a power switch, turn it off.
12. Plug in the power cord to the AC power source outlet.
13. If the AC power source outlet has a power switch, turn it on.
NOTE: The router powers on as soon as you connect it to power. The ACX7100-48L doesn't have a power
switch.
14. Verify that the AC LED on the power supply is lit green. If the LED is lit steadily amber or is blinking amber,
disconnect the power supply from the power source, and replace the power supply (see
ACX7100-48L Power Supplies
15. Repeat steps 7 through

Step 2: Up and Running

IN THIS SECTION

Plug and Play | 6

Customize the Basic Configuration | 7
Now that the ACX7100-48L is powered on, let's do some initial configuration to get it up and running on the network.
It's simple to configure and manage the ACX7100-48L using the CLI. You can also onboard and manage the
ACX7100-48L by using Paragon Automation. To onboard this device using Paragon Automation, see
Ready Devices with Paragon
Plug and Play
The ACX7100-48L router ships with factory-default settings that enable plug-and-play operation. These settings load as
soon as you power on the router.
in the ACX7100-48L Hardware
14 to power on the second power supply.
Automation.
Maintain the
Guide).
6
Onboard Cloud-