Table of Contents
Advertisement
Customize the Basic Configuration
You can easily customize the factory-default configuration with just a few commands. Initially, you'll need to make
changes through the console port. After you configure the management port, you can access the ACX7100-48L using
SSH and make additional configuration changes. You can always revert to the factory-default configuration whenever
you want.
Have the following information ready before you begin customizing the router:
• Hostname
• Root authentication password
• Management port IP address
• Default gateway IP address
• IP address and prefix length of remote prefixes
• (Optional) SNMP read community, location, and contact information
1.
Verify that the following default serial port settings are configured on your laptop or desktop PC:
• Baud Rate—9600
• Flow Control—None
• Data—8
• Parity—None
• Stop Bits—1
• DCD State—Disregard
2.
Connect the console port on the ACX7100-48L to a laptop or desktop PC using the RJ-45 cable and RJ-45 to
DB-9 adapter. The console (CON) port is the lower RJ-45 port on the right side of the port panel.
NOTE: If your laptop or desktop PC doesn't have a serial port, use a serial-to-USB adapter (not provided).
3.
At the Junos OS login prompt, type root to log in.
You don't need to enter a password. If the software boots before you connect your laptop or desktop PC to the
console port, you might need to press the Enter key for the prompt to appear.
re0 login: root
7
Advertisement
Table of Contents
