Step 2: Up And Running - Juniper SRX300 Quick Start Manual

Power On
Now that you've installed your SRX300 in the rack, you're ready to connect it to power.
1. Wrap and fasten one end of the electrostatic discharge (ESD) grounding strap around your bare wrist, and connect the
other end to a site ESD point.
2. Plug the DC connector end of the power cable into the power connector at the back of the SRX300.
3. Plug the AC adapter end of the power cable into the power supply adapter.
4. If the AC power source outlet has a power switch, turn it off.
5. Plug in the power cord to the AC power outlet.
6. If the AC power outlet has a power switch, turn it on.
The SRX300 powers up as soon as you connect it to power. When the STAT LED on the front panel is lit solid green,
the SRX300 is ready to use.

Step 2: Up and Running

IN THIS SECTION
SRX300 Provisioning Options | 6
Initial Configuration Using the CLI | 6
Now that the SRX300 is powered on, let's do some initial configuration to get it up and running on the network.
5