Advertisement
Step 2: Up and Running
IN THIS SECTION
Install the SRX Series Firewall in a Rack | 5
Connect to the Network and Power On the SRX Series Firewall | 5
Install the SRX Series Firewall in a Rack
The rack installation and power-on procedures vary slightly for each SRX Series firewall. For instructions specific to your
SRX Series firewall, see the applicable hardware guide on the
Connect to the Network and Power On the SRX Series Firewall
NOTE: Certain tasks in this procedure require you to configure or connect to services within your local network.
Please be aware that we don't provide instructions on how to configure or locate these services.
1. Connect the 0/0 port (ge-0/0/0 interface) to the WAN network. The interface receives an IP address from the DHCP
service provided by the ISP.
2. Open ports TCP 443 and TCP 2200 on your Internet firewall to allow outbound communication between the SRX
and the Mist cloud. You also need to open port TCP 6514 to allow the SRX to send traffic logs to the Mist cloud.
3. Connect an Ethernet cable to any traffic (revenue) port on the SRX firewall and to your local network.
4. Connect power to the firewall.
5. Wait for a few minutes for the firewall to boot completely.
The SRX firewall should now appear as green/connected in the Mist portal. Congratulations! You've successfully
onboarded your cloud-ready SRX Series firewall.
Juniper Mist Supported Hardware
5
page.
Advertisement
